Post 4: Finishing the base For this post, the photo's don't realy need explaining. I tried using weathering powders on the barrel and tank trap, as I had not used them before. I am quite happy with the end result. The blending of colour in the greens of the beam haven't come out at all in the photo, so perhaps they are too understated. ...
Post 3: Explosion and Undercoating. Sand and stone were added with the help of some PVA, and I then modelled the explosion using green-stuff modelling clay. Not a very technical piece of sculpting work, and not something I am good at, but fit for purpose. Next I under-coated the base, and started thinking about the colour scheme. ...
Updated 01-05-2013 at 07:27 AM by payzahh
Post 2: Creating the base. A router with a round-over edge forming bit, was used on the top side of the base. I then used a Dremmel multi to carve out a groove, from where the rod exits the wood to the edge of the base. This will help model the destruction caused by the passing of the "death ray" Attachment 17925 A few inches of the rod on the end that will attach to the model, was re-shaped using a grinder. The idea was to create an ...
Privacy Policy | Terms and Conditions | Contact Us | The Legion
Copyright © 2001-2018 CMON Inc.
Go to Profile
Mark as Read
