payzahh

Post 2: Creating the base.

A router with a round-over edge forming bit, was used on the top side of the base.
I then used a Dremmel multi to carve out a groove, from where the rod exits the wood to the edge of the base.
This will help model the destruction caused by the passing of the "death ray"
Attachment 17925

A few inches of the rod on the end that will attach to the model, was re-shaped using a grinder.
The idea was to create an ...

Tags: base, doom scythe, modeling, necron, warhammer 40k

Categories

Painting and Modelling , Tabletop Gaming , Warhammer 40K