Infamy miniatures. Toad 2 - Blogs - CoolMiniOrNot Forums
View RSS Feed


Infamy miniatures. Toad 2

Rate this Entry
Ok, so this morning I started to work on the base a little. I recently backed the Happy Seppuku kickstarter to get a bunch of rubber stamps to use for basing, bits, and dioramas. This is what I decided to use to make the base for Toad.

I started with the flagstone stamp, and mixed up some putty, I had to go back and add more, this is a big base. That is the reason for the 2 different colored putties on the base in the picture. I wet the stamp down a little and then pressed the base into the stamp for about 5 seconds. Wetting the stamp helps keep the putty from sticking and decreasing the quality of the impression. Here is a pic of the impression left on the base. It hasn't dried and hardened yet so painting will have to come later.
Name:  .jpg
Views: 139
Size:  7.5 KB
I plan to have toad standing in front of part of a brick wall and so I next too the standard brick stamp pattern and mixed up some more putty. I pressed the putty into the stamp starting at the bottom of the stamp so that when it hardens and I remove it from the stamp it should take minimal trimming to get a flat bottom to attach to the base. For the wall I am allowing it to harden on the stamp. when it hardens it should come right off and be ready to attach to the base. Here is a pic of the putty on the stamp, allowing you to get a look at the quality of the stamps from Happy Seppuku.
Views: 134
Size:  7.3 KB

I will update later with the final hardened pieces, and then you will see them again on the final piece.

Submit "Infamy miniatures. Toad 2" to Digg Submit "Infamy miniatures. Toad 2" to Submit "Infamy miniatures. Toad 2" to StumbleUpon Submit "Infamy miniatures. Toad 2" to Google Submit "Infamy miniatures. Toad 2" to Facebook

Updated 12-02-2013 at 03:43 AM by Osugambit

Tags: None Add / Edit Tags
Painting and Modelling


Privacy Policy  |   Terms and Conditions  |   Contact Us  |   The Legion

Copyright © 2001-2018 CMON Inc.